XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Flywheel collet question. https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=3308 |
Page 1 of 1 |
Author: | Zombietime [ Sun Mar 26, 2006 12:30:59 ] |
Post subject: | Flywheel collet question. |
How far should the flywheel fit on the collet to be acceptable? I just rebuilt my RB S5 and put a new flywheel and clutch (all stock xray parts) and with the three washers, the collet and then the flywheel tightened I fall within the 11.0 - 11.2 spec. I take it the flywheel doesn't need the collet completely in it to be proper. Is this correct? Just want to make sure as I didn't check when I took off the mugen clutch setup that was on the engine previously. Thanks. |
Author: | Chris Crews [ Sun Mar 26, 2006 19:25:43 ] |
Post subject: | |
If i am understanding you properly in that the collet does not have to be 100% all the way through the flywheel then yes, you are correct. Usually it only fits about 75% through the flywheel. |
Author: | Zombietime [ Sun Mar 26, 2006 22:38:37 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |