XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
tq set: rear toe in https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=3058 |
Page 1 of 1 |
Author: | Kristof [ Tue Feb 14, 2006 01:25:27 ] |
Post subject: | tq set: rear toe in |
hi guys Can you give the car more than 2° rear toe in with the tq parts or did i need use the old back plate 2°-4°? Greetings |
Author: | Casper [ Tue Feb 14, 2006 01:36:52 ] |
Post subject: | |
Use the alum rear hubs to get 2 deg out there. |
Author: | Astroracer [ Tue Feb 14, 2006 13:15:17 ] |
Post subject: | |
I think the rear plate included with the TQ set allows 1.5 - 3.5deg of toe-in, as it comes set with 2.5deg with the 0 bushing which means you could go 1deg either side of that. I'm sure somebody will correct me if i'm wrong ![]() |
Author: | Stanley Wangsanegara [ Tue Feb 14, 2006 17:55:52 ] |
Post subject: | |
Author: | Astroracer [ Tue Feb 14, 2006 19:07:04 ] |
Post subject: | |
Author: | Stanley Wangsanegara [ Wed Feb 15, 2006 08:14:00 ] |
Post subject: | |
Hi Astroracer, Honestly I never try it in the set-up. I just measure TQ set rear place the distance between the two holes and compare it with the original 2-4 degree plate. The distance between the two plate is the same. So, I tought that it is intentionally made as 2-4 degree block. It might be the bushing in your front plate (Rear Gear Box) already have too much slope so that the degree reading is not correct. Maybe.. Just Maybe.. |
Author: | guy02 [ Sun Feb 19, 2006 12:37:55 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |