| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Engine mount https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=2803 |
Page 1 of 1 |
| Author: | Rugge [ Thu Jan 05, 2006 08:13:39 ] |
| Post subject: | Engine mount |
Hi, I have the optional engine mount for a Novarossi P5 assembled on my XB8R. Will an RB Concept engine fit on the very same engine mount or do I have to purchase a new one?? Thanx! -R |
|
| Author: | nolec5 [ Thu Jan 05, 2006 08:19:15 ] |
| Post subject: | |
Yes, it should since they are both Nova. based engines. |
|
| Author: | imaxx21 [ Thu Jan 05, 2006 08:21:29 ] |
| Post subject: | |
yes ive used both.... |
|
| Author: | Rugge [ Thu Jan 05, 2006 09:18:48 ] |
| Post subject: | |
| Author: | Rugge [ Thu Jan 05, 2006 11:42:42 ] |
| Post subject: | |
| Author: | Sami L [ Thu Jan 05, 2006 13:05:33 ] |
| Post subject: | |
| Author: | slim [ Thu Jan 05, 2006 19:10:05 ] |
| Post subject: | |
| Author: | ChrisP [ Thu Jan 05, 2006 22:18:49 ] |
| Post subject: | |
| Author: | Diesel Racer [ Thu Jan 05, 2006 22:22:14 ] |
| Post subject: | |
| Author: | crusher [ Fri Jan 06, 2006 02:48:39 ] |
| Post subject: | |
| Author: | dxray530 [ Tue Jan 10, 2006 22:57:07 ] |
| Post subject: | mounting a OS Vspec |
| Author: | Robert G [ Tue Jan 10, 2006 23:50:46 ] |
| Post subject: | v-spec |
Thers no problems with clearance with the v-spec. I really havent noticed any problems installing any of them... You shouldnt be worried about that, just put it in and race:-) Robert |
|
| Author: | REDLINEIT [ Wed Jan 11, 2006 10:28:38 ] |
| Post subject: | v spec |
I run the v spec on mine but i have a problem with fly wheel not reaching down enough for the bump start i use the ofna strter box that the only problem i have did you need to change the engine mounts i used the standard ones the XB8 comes with. |
|
| Author: | Robert G [ Wed Jan 11, 2006 17:18:53 ] |
| Post subject: | Starterbox |
Maybe your starterbox has to big diameter for the chassies. I think size varies from brand to brand of starterboxes...I use mugen one and it works great. See if they have a smaller wheel for it.... or the last thing to grind the sides of the flywheel hole abit. Robert |
|
| Author: | Sami L [ Wed Jan 11, 2006 17:22:10 ] |
| Post subject: | |
Or possibly try to get rubber higher placing shims under rubber inside starterbox (and possibly under engine). I'm running Hobao plastic box, put 2-3mm under rubber mounts and box engine. (And slightly Dremel the box itself  ) This way I got the whole thing bit higher and much better.
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|