XRAY - Model racing cars

My servo saver in XB9e is getting to move hardly when a dust gets inside. On a dusty track there is an issue. I loosen the spring to lower the pressure, but this affects handling of a car while the saver is clean at the beginning. Dust comes between the parts of saver and makes scratches on them.

I bought a spare servo saver, which was intended for xb9 model (#352512), but is not the same. Servo arm of saver is lower then stocked piece. I would have to put a lot of shims to keep the servo rod horizontal, which I don't like.

Best way to install on Gameguardian

same problem here.

Hi khaneshwar for the servo saver in XB9e I would suggest you not to put any more money, if you are a rc geek learn 3d designing and get a 3d printer.
Take dimensions of your servo motors and create the design, print them custom so they fit like a glove protecting your expensive servos. Also you can try thingiverse, a site that provides free 3d models of a whole lot of rc stuff, I hope you get something useful there. Accelerate high driver !