| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Servo saver is getting to move hardly under dusty conditions https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=27431 |
Page 1 of 1 |
| Author: | khaneshwar [ Wed Mar 06, 2019 14:51:34 ] |
| Post subject: | Servo saver is getting to move hardly under dusty conditions |
My servo saver in XB9e is getting to move hardly when a dust gets inside. On a dusty track there is an issue. I loosen the spring to lower the pressure, but this affects handling of a car while the saver is clean at the beginning. Dust comes between the parts of saver and makes scratches on them. I bought a spare servo saver, which was intended for xb9 model (#352512), but is not the same. Servo arm of saver is lower then stocked piece. I would have to put a lot of shims to keep the servo rod horizontal, which I don't like. |
|
| Author: | pinocadiso [ Wed Mar 13, 2019 08:28:33 ] |
| Post subject: | Re: Servo saver is getting to move hardly under dusty condit |
Best way to install on Gameguardian |
|
| Author: | destroix [ Mon May 06, 2019 02:13:41 ] |
| Post subject: | Re: Servo saver is getting to move hardly under dusty condit |
same problem here. |
|
| Author: | Angelagates [ Wed May 29, 2019 17:13:18 ] |
| Post subject: | Re: Servo saver is getting to move hardly under dusty condit |
Hi khaneshwar for the servo saver in XB9e I would suggest you not to put any more money, if you are a rc geek learn 3d designing and get a 3d printer. Take dimensions of your servo motors and create the design, print them custom so they fit like a glove protecting your expensive servos. Also you can try thingiverse, a site that provides free 3d models of a whole lot of rc stuff, I hope you get something useful there. Accelerate high driver ! |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|