| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Servo saver is getting to move hardly under dusty conditions https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=27396 |
Page 1 of 1 |
| Author: | khaneshwar [ Sun Feb 17, 2019 06:51:17 ] |
| Post subject: | Servo saver is getting to move hardly under dusty conditions |
My servo saver in XB9e is getting to move hardly when a dust gets inside. On a dusty track there is an issue. I loosen the spring to lower the pressure, but this affects handling of a car while the saver is clean at the beginning. Dust comes between the parts of saver and makes scratches on them. I bought a spare servo saver, which was intended for xb9 model (#352512), but is not the same. Servo arm of saver is lower then stocked piece. I would have to put a lot of shims to keep the servo rod horizontal, which I don't like. Does XB9 use two different versions of servo savers Any advice to avoid blocking the movement of servo saver is welcome. Thanks |
|
| Author: | johnricher [ Tue Jul 23, 2019 16:38:09 ] |
| Post subject: | Re: Servo saver is getting to move hardly under dusty condit |
gret |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|