XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Front Universal/Steering Servo https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=2443 |
Page 1 of 1 |
Author: | Brian M [ Thu Oct 20, 2005 17:21:47 ] |
Post subject: | Front Universal/Steering Servo |
Author: | Giorgi50 [ Thu Oct 20, 2005 18:00:25 ] |
Post subject: | |
Author: | plaidfish [ Fri Oct 21, 2005 21:06:26 ] |
Post subject: | |
Author: | Giorgi50 [ Sat Oct 22, 2005 04:46:44 ] |
Post subject: | |
shim it up .5mm's behind the servo grommets. It cant hurt. If it does not look like its contacting while spinning drivetrain with your hand, it could be rubbing when drivetrain spools up at full wood. Causing more movement than you can see than when simply rolling it. |
Author: | ajoiner490 [ Sat Oct 22, 2005 06:53:10 ] |
Post subject: | |
If you have the stock front brace instead of the hop-up piece, it may be rubbing if it comes loose. I had that problem and thought it was the servo, but th efront brace came a little loose and at full throttle would wobble just enough to rub the uni. Hope it helps ![]() |
Author: | Giorgi50 [ Sat Oct 22, 2005 15:15:54 ] |
Post subject: | |
Author: | ajoiner490 [ Sat Oct 22, 2005 19:00:12 ] |
Post subject: | |
Author: | Kevin Slusser [ Sun Oct 23, 2005 09:04:52 ] |
Post subject: | |
Author: | Giorgi50 [ Mon Oct 24, 2005 05:34:37 ] |
Post subject: | |
Yes, Kevin . The 94359z heatsink servo will fit withOUT modifications on the XB8. Just make sure to use the supplyed grommets. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |