XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
captured Tie rods https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=2197 |
Page 1 of 1 |
Author: | Giorgi50 [ Sat Sep 03, 2005 04:26:52 ] |
Post subject: | captured Tie rods |
When is Xray going to release these ??? This is a must, cause once they wear, the steering rods pop off upon adjustment. Any dates ??? please ??? |
Author: | Giorgi50 [ Sat Sep 03, 2005 04:33:52 ] |
Post subject: | |
how about this stuff too ??? ![]() |
Author: | showtime [ Sat Sep 03, 2005 07:55:10 ] |
Post subject: | |
Author: | J.W [ Sat Sep 03, 2005 12:19:37 ] |
Post subject: | |
Author: | konastab01 [ Sat Sep 03, 2005 13:37:11 ] |
Post subject: | |
Author: | speed08 [ Sat Sep 03, 2005 14:06:36 ] |
Post subject: | |
Author: | FreakOfNature [ Sun Sep 04, 2005 07:40:48 ] |
Post subject: | |
Author: | Booyah [ Sun Sep 04, 2005 07:55:44 ] |
Post subject: | |
Author: | Barkley Abernethy [ Sun Sep 04, 2005 08:07:08 ] |
Post subject: | |
Author: | Giorgi50 [ Sun Sep 04, 2005 08:16:00 ] |
Post subject: | |
Author: | NateB8 [ Sun Sep 04, 2005 09:32:04 ] |
Post subject: | |
Author: | guy02 [ Sun Sep 04, 2005 10:40:11 ] |
Post subject: | |
I wish for completely new rod and ends |
Author: | Giorgi50 [ Sun Sep 04, 2005 19:43:36 ] |
Post subject: | |
Good Question Nate ! From the looks of it, it looks like that might be the case. But I'm sure everything will be worked out before production. ![]() |
Author: | NateB8 [ Sun Sep 04, 2005 23:18:12 ] |
Post subject: | |
Maybe they should make the captured part concave instead of convex where it is not flat on the buckle side but curved on that side to give more clearance. The width of the captured end would prevent it from poping off. ??? |
Author: | Giorgi50 [ Sun Sep 04, 2005 23:41:38 ] |
Post subject: | |
good call !! |
Author: | showtime [ Mon Sep 05, 2005 08:12:39 ] |
Post subject: | |
you also have to consider the head needing to be both deep enough for an allen driver but not so tall it hits the wheel! |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |