XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Servo Ratings for Throttle amd Steering https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=2038 |
Page 1 of 1 |
Author: | Gap Man [ Mon Aug 01, 2005 14:42:51 ] |
Post subject: | Servo Ratings for Throttle amd Steering |
Author: | *HOKE* [ Mon Aug 01, 2005 16:01:53 ] |
Post subject: | |
Author: | Roberto777XB8 [ Mon Aug 01, 2005 16:10:14 ] |
Post subject: | |
Author: | David Joor [ Tue Aug 02, 2005 01:30:18 ] |
Post subject: | |
I use the new KO Propo servos that are designed for 8th scale(PDS-2366 ICS). I prefer torque servos all around because I like holding power on the steering and the brakes. They are 180.5oz-in (13.0kg-cm), speed 0.13S @ 60 deg http://www.shopatron.com/product/produc ... .234.0.0.0 |
Author: | xbspud [ Tue Aug 02, 2005 04:07:14 ] |
Post subject: | |
I personally like the airtronics 94359 it is not a digital servo features High Torque Aluminum Gear Double Ball Bearing Servo Aluminum Heat Sink Case Z-Connector Coreless Motor Torque: 160 in.-oz. (@4.8 V) 200 in.-oz. (@6.0 V) Speed: 0.13/60 deg (@4.8 V) 0.10/60 deg (@6.0 V) don't see where the kg-cm I like the non digital servo's if money is an issue you can use the 94358 does not have a heat sink but is the same servo as listed above rating torque and speed. I should have setup for the throttle servo the same but I went with the 94360 to save 20.00 it is alot faster than the above and is 125 in-oz but that is just me I am sure you would be happy with a good high torque high speed servo. |
Author: | Gap Man [ Tue Aug 02, 2005 08:11:55 ] |
Post subject: | |
Great, Thanks a lot everyone for your replies - this forum and all on it is one of the reasons I think Xray is the brand to have.... ![]() |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |