XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Hudy table setup https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=19313 |
Page 1 of 1 |
Author: | d87 [ Wed Apr 27, 2016 11:40:14 ] |
Post subject: | Hudy table setup |
Hello i write from spain. Good morning. wanted to know if you use Hudy table settings. More people say me, that measuring the degree of the wheels must be given more degrees on the table that mark. example. to have 2 degrees in the car, I have to put 4 on the table. Is that so? Thanks |
Author: | Zerodefect [ Thu Apr 28, 2016 01:04:47 ] |
Post subject: | Re: Hudy table setup |
Possibly, yes. I set/hold my car on the 30mm Hudy blocks. That way the numbers recorded are repeatable. You may want to double check your camber settings with your tires on after dropping the car. Just make a mental note what level your suspension arms sit at. My ride height is almost always "arms slightly below level". So on the Hudy setup station after setting my baseline with the car on the 30mm blocks, I'll let the car rise up to "arms almost level" and see what reading's I have. 4 degrees on the blocks, may only be 3 degrees at ride height. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |