XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
XB8 - New to offroad - Assistence https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=18911 |
Page 1 of 1 |
Author: | DeonG [ Tue Dec 09, 2014 10:50:02 ] |
Post subject: | XB8 - New to offroad - Assistence |
Hi, I am having a few issues that need help with while building my first XB8 1. The rear arms are binding once fully assembled? My solution would be to sand the 2mm shims down to 1.8mm to free this up. ( arms are free if I loosen the mounting screws 1/4 turn) 2. Servo saver - Manual states to have 4-5mm of the thread sticking out the top once you thread the top on and tighten down the spring, The maximum I can get is 2.5mm down and it is extremely tight already that I would need pliers to tighten it further. Is this correct as I have checked everything correctly installed. Can I leave it at 2.5mm and test once the car is on the track? Thanks Deon |
Author: | rick oxley [ Tue Dec 09, 2014 23:01:42 ] |
Post subject: | Re: XB8 - New to offroad - Assistence |
i run my servo saver at 2mm on high grip track and its fine,5mm broke servo for me, hinge pins should be ok with screws 1/4 turn loose just make shore the pin does not bind in the arm as they are tight as new. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |