Been trialing this idea now for 6 months and has worked realy well, because ive had no luck sealing my shocks with the orange orings i decided to see if i could seal my front and rear arms to stop them from binding up with dirt all the time, i removed one of the 2mm spacers that sit each side of the arm and then put an oring either side of the arm and then placed the other 2mm spacer to the rear of the arm, this does sit the arm forward abit but you can compensate for that out on the hub, put it back together and you will see the orings pull in on the arms and close the gap nicely, there will obviously be some movment in the arm but this dose not seem to efect the cars handleing, since i have done this ive never had probs with arm bind, stays smooooth all the time, this idea may not siut everyone but some may like it.
My sugestion to Xray is to recess each end of the arm half the thickness of the oring so the oring sits snug in the arm and then you can go back to using both of the 2mm spacers, again just a sugestion!!!!, what do you think!
DSC00050.JPG [ 126.76 KiB | Viewed 3491 times ]
