XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Throtle servo at XB808 11' https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=11191 |
Page 1 of 1 |
Author: | Nikos Georgiadis [ Sat Mar 05, 2011 12:36:09 ] |
Post subject: | Throtle servo at XB808 11' |
When i built the new XB 808 11" i had a problem on step 10 at page 29. My servo(brushlesh bls351 futaba) touching the chassis. I must use 2mm shims to alter the height of the servo and when i use this shims the servo touching the body. Could anyone help me anout this? Thank you in advance. |
Author: | Christian Schamp [ Sun Mar 06, 2011 10:31:01 ] |
Post subject: | Re: Throtle servo at XB808 11' |
Hi I have the same problem... I use the Sanwa ERG-WX and its 5mm higher as the topdeck ![]() |
Author: | blade954 [ Sun Mar 06, 2011 15:20:50 ] |
Post subject: | Re: Throtle servo at XB808 11' |
Yep i also had the servo bottoming out on the chassis and side mud guard, I run Fatuba BLS452 in the Throttle so i had to do some remodeling of the plastic fits in and worked great. I also had to cut a small section away from steering top corner. |
Author: | lauri [ Sun Mar 06, 2011 21:20:19 ] |
Post subject: | Re: Throtle servo at XB808 11' |
What's the case with the throttle/brake servo being moved outwards? Can you move it back inwards (like 2009, 2010) if you use stock spur gear? Cut away the carbonfiber bridge and make new holes so servo sits where it has always been? |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |