XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Building XB808E https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=10825 |
Page 1 of 1 |
Author: | Braxx [ Tue Sep 28, 2010 21:27:24 ] |
Post subject: | Building XB808E |
The shaft of the Mamba Monster 2200KV is hitting the receivercase so i can't install it? ![]() |
Author: | RCMD [ Wed Sep 29, 2010 00:27:26 ] |
Post subject: | Re: Building XB808E |
See my previous post here and on rctech. There is a good discussion about possible fixes there by Bryan from Rc America. His response starts on page 13 and discussion continues. I just dremeled out room for motor shaft. That one looks even longer than my Tekin tough. You could dremel enough off and use a screw from the bottom of the new hole and a nut on top. Link: http://www.rctech.net/forum/electric-of ... -e-13.html |
Author: | Zerodefect [ Fri Nov 12, 2010 02:11:31 ] |
Post subject: | Re: Building XB808E |
Just cut the excess motor shaft off. Why is this a huge issue on every forum. A dremel and a cutting wheel will go right through that shaft in 3 min. Then just bevel the edges with stone a little. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |