Joined: Tue Jul 20, 2010 00:14:48 Posts: 4 Location: Miami, Fl
|
Bren, read the post on the pinion but still did not find the answer I was looking for, just finished building my new 808 Buggy 2010 spec with the three bearing set up but did not use the Alu spacer provided in the front or back diff's as I could not get it to fit flush. Is the alu spacer still needed with the three bearing set up and will the final assembaly of the three bearing and spacer sit flush allowing the three final screws that hold the bearings down to sit properly in the groves or will this new set up stick out. Hope I explained my self to where you can help me dying to continue with the final of the engine, pipe and servos to start running thanks. dp
|
|