XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
2010 Pinion Gear Setup https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=10695 |
Page 1 of 1 |
Author: | drunk driver [ Mon Jul 26, 2010 17:02:30 ] |
Post subject: | 2010 Pinion Gear Setup |
Guy's just finished putting together my 808 2010, while building the front and rear diffs noticed that there was a alu spacer that i just could not get to fit. My guess is that with the new three bearing system this spacer is not needed as the set up will not sit in rite for the three locking screws to sit flush, is this asumption correct. dp |
Author: | Barkley Abernethy [ Tue Jul 27, 2010 00:39:42 ] |
Post subject: | Re: 2010 Pinion Gear Setup |
check your first bearing is all the way home . goes bearing then shaft then spacer .next bearing is tight and needs wiggled in then the last bearing . screw flush then back a toutch . |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |