| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| 808 2010 problem? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=10463 |
Page 1 of 1 |
| Author: | cornish boy [ Mon May 10, 2010 21:34:26 ] |
| Post subject: | 808 2010 problem? |
hi guys i have recently built up my 2010 using the aluminum hinge pin holders both f and r and i it looks to me like the rear end seems to raise at the front and does not look right any ideas? cheers jordan |
|
| Author: | Quietman [ Mon May 10, 2010 22:11:12 ] |
| Post subject: | Re: 808 2010 problem? |
You have to use the other ones the r2 blocks or dremel the chassis slighty |
|
| Author: | cornish boy [ Mon May 10, 2010 22:21:16 ] |
| Post subject: | Re: 808 2010 problem? |
hi mate can you define OTHER ONES plastic standard or is there another set of alu ones for the 2010 |
|
| Author: | Bren Ralls [ Mon May 10, 2010 23:09:33 ] |
| Post subject: | Re: 808 2010 problem? |
The 0-2 anti squat plate will not fit the 2010 car, it fouls the chassis & lifts the gear box of the chassis. You can grind the chassis to make it fit but find ourselves running in 2 deg postition most of the time now. Run the 2-4 anti squat plate & run in 2 deg position, it will look close & will look as if the gearbox is lifted, just remove the wishbones & you will see all is fine. |
|
| Author: | cornish boy [ Mon May 10, 2010 23:34:53 ] |
| Post subject: | Re: 808 2010 problem? |
cheers i will try that tomorow |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|