XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
2nd chipped bevel gear 808E https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=10414 |
Page 1 of 1 |
Author: | customworksking [ Mon Apr 26, 2010 01:26:58 ] |
Post subject: | 2nd chipped bevel gear 808E |
ok I started with an 808/09 .I up dated the car to the 2010 I also run the monster slipper/diff ,alum rear brace,new chassis, to try n stop this... the inner bearing "rear diff" lost its shield as well can it jam and chip it? .. I only had40 min run time on the center bearings.. even with the bigger bearings they come apart like the small.... I can't offord to replace gears every month |
Author: | Edumakated [ Mon Apr 26, 2010 21:15:26 ] |
Post subject: | Re: 2nd chipped bevel gear 808E |
You are supposed to take the shield off the bearings in the front and rear diffs. There is no reason you should be chipping the gears in the front and rear. I have been the original front and rear diffs for 2 years now. |
Author: | customworksking [ Mon Apr 26, 2010 21:38:45 ] |
Post subject: | Re: 2nd chipped bevel gear 808E |
i was never told to do so.. |
Author: | Zerodefect [ Sat May 15, 2010 03:08:15 ] |
Post subject: | Re: 2nd chipped bevel gear 808E |
Yup, no shields in the gear boxes. Just on the outside sides of the diff cases. I'm trying Boca revolutions bearings with shields, but I doubt they'll be any better. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |