The FULL THROTTLE Spectrum glitch:
Since I switch receivers from buggy to buggy, I figured out that the problem with the spectrum failsafe is due to how the module is bond and the glitch can occur with the transmitter set right and re-bond.
When setting up the binding, the receiver is off and the bind button is held while the power is turned on. The receiver will have a prominent bright flash. The problem occurs with binding the MODULE. When the transmitter is off, and holding full brake and the bind button, the transmitter is then turned on. The INITIAL quick and faint (weak) almost glitchy flash on the MODULE is when you should let go of the bind button.
IF I wait for the prominent flash like on the receiver to release the bind button, it is too late. when I turn off the transmitter, the failsafe will often go immediately to full throttle (irregardless of settings).
If release I the bind button immediately after the initial quick and weak glitch looking flash, the Failsafe will work properly everytime.
The instructions do not clearly explain that the receiver and module have different flashes.
|