XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Xray Clutch Setup https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=9&t=114 |
Page 6 of 7 |
Author: | imaxx21 [ Wed Nov 24, 2004 06:42:16 ] |
Post subject: | |
Author: | Bob The Builder [ Wed Nov 24, 2004 09:53:29 ] |
Post subject: | |
Author: | Booyah [ Wed Nov 24, 2004 10:31:55 ] |
Post subject: | |
Author: | imaxx21 [ Wed Nov 24, 2004 11:00:03 ] |
Post subject: | |
they also make a gold one..... |
Author: | direct_x [ Thu Nov 25, 2004 02:32:38 ] |
Post subject: | |
Author: | z-man [ Thu Nov 25, 2004 09:03:34 ] |
Post subject: | |
Author: | showtime [ Thu Nov 25, 2004 09:24:45 ] |
Post subject: | |
i just reached into my toolbox to see what size the flywheels are in comparison to each other & the XRAY flywheel is Exactly the same size as the Trinity Kfactory Kyosho wheel! i couldn't check my Mugen flywheels as they're all on engines ![]() but i do know that they are the same size as the K-factory ones as i have used either flywheel in either car ![]() |
Author: | direct_x [ Thu Nov 25, 2004 15:24:33 ] |
Post subject: | |
Author: | Desperado [ Thu Nov 25, 2004 16:03:55 ] |
Post subject: | |
Author: | z-man [ Thu Nov 25, 2004 16:41:56 ] |
Post subject: | |
Author: | Desperado [ Thu Nov 25, 2004 17:41:24 ] |
Post subject: | |
Sure, try |
Author: | z-man [ Thu Nov 25, 2004 21:02:15 ] |
Post subject: | |
Author: | nitrojim [ Sat Nov 27, 2004 17:44:18 ] |
Post subject: | |
OK I checked a K2 flywheel and MBX5 and there both 33.80mm I did not take my engine out of my xb8 so if someone has that we can settle the debate. |
Author: | JerKap [ Sat Nov 27, 2004 19:06:56 ] |
Post subject: | werks clutch |
Someone mentioned that Werks was coming out with a new clutch that can be adjusted without taking the motor out... Any updates to when this will be in the stores.. Also if I buy a Werks Clutch for my XRAY ,, is there one with a 33mm flywheel? Thanks.. |
Author: | team lobo [ Sun Nov 28, 2004 04:13:43 ] |
Post subject: | |
Author: | muddybuggy [ Sun Nov 28, 2004 19:28:35 ] |
Post subject: | |
Author: | BuLLdoGG [ Sun Nov 28, 2004 19:54:36 ] |
Post subject: | |
The European distributor and I believe, the original producer of these clutches is |
Author: | David Joor [ Mon Nov 29, 2004 04:33:58 ] |
Post subject: | |
Author: | Mike Dana [ Mon Nov 29, 2004 19:37:40 ] |
Post subject: | |
ba ha ah aha ha ![]() j/k DJ ![]() ygm |
Author: | Desperado [ Tue Nov 30, 2004 02:08:29 ] |
Post subject: | |
The Werks clutch for the XB8 is available from [url]www.rcmodelsport.com [/url] . Cost is $69:99 ![]() |
Page 6 of 7 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |