808 optional engine mount

Keith · **Posted:** Mon May 12, 2008 19:57:20

http://www.teamxray.com/teamxray/news/n ... on%20Parts

HulkRay · **Posted:** Mon May 12, 2008 21:15:19

When will they will be out? Guys I was breakin my engine this weekend and I took the engine off and on a lot of times and the mesh still kept well. I took the engine off by the engine screws not the mount screws so I did not had to reset the mesh at all.. What would be the advantage of these mounts other than it looks really nice...

THanks
Felix

Rocco Margiotta · **Posted:** Mon May 12, 2008 21:52:59

You have a straight shot at the screws that secure the mount, so you don't have to risk your ball end wrench or remove the head of the motor.

Robin Frischkopf · **Posted:** Mon May 12, 2008 21:57:07

Also as there's no aligning pin the mesh can still be way off if the engine moves a bit when you reinstall it. And without removing the head you can't put enough pressure on the screw.
I've seen some lost engine screws these past few weeks and it was always because of this.

HulkRay · **Posted:** Mon May 12, 2008 21:58:17

ok when are they shipping or the shops already have them. Also which will be good for my GO Tech Engine .21..

Rocco Margiotta · **Posted:** Mon May 12, 2008 22:21:44

Hopefully they're shipping within this week, but I won't know for sure until later on this week.

As far as the GO tech engine goes, I am not sure.... Sorry!

HulkRay · **Posted:** Mon May 12, 2008 22:35:11

Rocco aren't you suppose to know everything?? :wink:

Barkley Abernethy · **Posted:** Tue May 13, 2008 00:23:18

os mount for a go get em

Rocco Margiotta · **Posted:** Tue May 13, 2008 00:36:41

Tank time · **Posted:** Tue May 13, 2008 01:37:56

Raymond Norte · **Posted:** Tue May 13, 2008 03:05:34

HulkRay · **Posted:** Tue May 13, 2008 03:25:41

gtsum · **Posted:** Tue May 13, 2008 05:01:27

Keith · **Posted:** Tue May 13, 2008 17:16:21

dbarnes · **Posted:** Tue May 13, 2008 19:22:17

Keith · **Posted:** Tue May 13, 2008 21:35:23

zieluch · **Posted:** Wed May 14, 2008 22:55:33

I thing this pins holder are worser then the standart ones. I prefer made from alu but for standard pins.

skidmark77 · **Posted:** Wed May 14, 2008 23:17:25

I use regular lock washers on the engine and mount with no issues.

http://www.tonysscrews.com/product.sc?c ... oductId=98

Oli · **Posted:** Mon May 19, 2008 16:30:39

Rocco Margiotta · **Posted:** Mon May 19, 2008 17:04:19

I'm not sure about your 'neck of the woods' but they are on the way to us, so check with the UK distributor to make sure.

XRAY - Model racing cars

808 optional engine mount

Who is online