808 diff case - shaft outdrive

Bazza · **Posted:** Thu Jan 01, 2009 20:06:32

I'm going to find this hard to explain...

The centre driveshaft that is...do you guys place anything over your shafts to prevent dust/debris getting into the diff case or pins in shaft?

Or do they make CVD boots for the centre drivehshafts?

The actual driveshafts from the diff outdrives are well sealed by the diff case

just wondered if anyone had covered their centre shaft (pinion) with anything?

Sorry, found that hard to describe...have a look at your diff case, the centre shaft is what I am talking about, LOL

Bazza

daz.fx · **Posted:** Fri Jan 02, 2009 01:39:06

While it's wet i pack gorilla snawt on the face of the bearing so it seals the casing from water washing straight in.
Before i did this, a few days after a wet race i took a gearbox screw out of the bottom of the chassis and water drained out, not good.

Robin Frischkopf · **Posted:** Fri Jan 02, 2009 03:33:05

Bazza · **Posted:** Fri Jan 02, 2009 11:04:17

daz.fx · **Posted:** Fri Jan 02, 2009 21:45:27

Bazza · **Posted:** Fri Jan 02, 2009 23:10:53

Bazza · **Posted:** Sun Jan 04, 2009 23:20:58

Robin Frischkopf · **Posted:** Tue Jan 06, 2009 18:05:27

Bazza · **Posted:** Tue Jan 06, 2009 18:49:53

Keyser-Soze · **Posted:** Tue Jan 06, 2009 21:52:43

Bazza · **Posted:** Tue Jan 06, 2009 23:03:29

Robin Frischkopf · **Posted:** Tue Jan 06, 2009 23:30:18

Bazza · **Posted:** Wed Jan 07, 2009 00:23:55

Hmm, I'd prefer Xray to bring some out but not at Xray prices :shock:

Don't think I would want to be chopping my fairly new buggy about, to fit a rubber cover over the shafts, I'd rather an authentic Xray boot which fits snugly

cough cough

XRAY - Model racing cars

808 diff case - shaft outdrive

Who is online