XRAY - Model racing cars

How old are they? Do they have the 46 'T' or just the 46? This warranty was in effect up until about 2 years ago...

46T it's wierd cause I've never broke a tooth before and now all of a sudden 2 go.... clutch bearings are good gear mesh right ( for an xray) and I'm running the chassis braces with the updated motor mount. no crashing.

maybe just my luck. I got a ticket for not signaling and have to go to court for it at the same time.LOL maybe a full moon???:-)

Now i dont know if it will diagnose the problem but funny two gears have gone? Were they both in the same car? The reason i ask is i stripped clutch bell teeth on brand new clutch bells recently even though the mesh was good. After inspection i diagnosed the problem to be loose engine mount screws (the ones that hold the engine to the engine mount looking down one the car). There was just enough vertical play to cause a problem and strip teeth. Did not notice it until i stripped the engine right out? Maybe the same thing could be happening but instead effecting the spur rather than the clutch bell. I've always used the hotbodies spur. 2.5years and no problems with it. Got fed up with xray ones chipping/breaking. As i've not had a problem using the HB version i've never switched to the Xray updated ones?

Maybe it'll help to take a look but i know how irritating it is to strip a spur