XRAY 808e diff Bearing Problem

alport78 · **Joined:** Thu Mar 10, 2011 02:50:15 **Posts:** 5

HI
I want to try the bulkhead, pinion and bearing mod that some nitro guys do. Any one have any idea which center universals should I use for 808e?

alport78 · **Joined:** Thu Mar 10, 2011 02:50:15 **Posts:** 5

Bump!
Isn't there any brushless driver with that mod?

Mader · **Posted:** Mon Mar 14, 2011 03:35:42

Nobody has contacted me to make sleeves for an 808e but I can if you want. To figure driveshaft length just measure from the nose of the bulkhead to the middle of the slot in the center diff front and rear. Then go to the hobby shop or your buds house and see what you can find. Remember that the measurement would be from the end of the shaft coupler to the center of the drive pin.

udi · **Joined:** Fri Mar 09, 2012 06:55:56 **Posts:** 6

Hi Mader, just sent you a message
Does your spacer allow standard 8x16x5mm bearings to be used?

Reno Savoya · **Joined:** Mon Sep 12, 2011 13:42:52 **Posts:** 68

Hi guys

Unfortunately there are not much possibilities as if you use the 808 2011 bulkhead you can't use the center driveshafts, they will be too short. However, I races already 3 times and practices with my 808e and didn't have any problem with bearings! I use the 3 bearings with the spacers, and it's really reliable! Extra caution on the shimming and the shape of the gears for every race, but still fine!

Reno

XRAY - Model racing cars

XRAY 808e diff Bearing Problem

Who is online