XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Grip Roll Nightmare https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=9993 |
Page 1 of 2 |
Author: | Skiddins [ Mon Dec 21, 2009 15:05:59 ] |
Post subject: | Grip Roll Nightmare |
Author: | CarbonJoe [ Mon Dec 21, 2009 23:15:39 ] |
Post subject: | |
Author: | WEBBY1977 [ Tue Dec 22, 2009 03:30:44 ] |
Post subject: | |
Author: | Chris Adams [ Tue Dec 22, 2009 03:57:00 ] |
Post subject: | |
Author: | Martin Hudy [ Tue Dec 22, 2009 10:43:14 ] |
Post subject: | |
Author: | Skiddins [ Tue Dec 22, 2009 15:56:25 ] |
Post subject: | |
Author: | Charlie Ware [ Wed Dec 23, 2009 11:20:26 ] |
Post subject: | |
Author: | sidecarphil [ Wed Dec 23, 2009 11:44:50 ] |
Post subject: | Re: Grip Roll Nightmare |
Author: | Skiddins [ Wed Dec 23, 2009 13:29:45 ] |
Post subject: | Re: Grip Roll Nightmare |
Author: | Skiddins [ Mon Jan 04, 2010 01:07:44 ] |
Post subject: | |
Author: | Gary Lanzer [ Mon Jan 04, 2010 19:13:49 ] |
Post subject: | |
Do you have a setup sheet we can look at? I just wonder if you have widened the front end at the pivot pin mounts, I don't think the Hex increase is buying you the effect your looking for. |
Author: | Skiddins [ Mon Jan 04, 2010 21:49:06 ] |
Post subject: | |
Author: | RCMD [ Mon Jan 04, 2010 22:36:20 ] |
Post subject: | |
Author: | Skiddins [ Tue Jan 05, 2010 00:40:45 ] |
Post subject: | |
Author: | RCMD [ Tue Jan 05, 2010 01:03:33 ] |
Post subject: | |
I am not sure the exact weight springs I have on without looking at my car. I know I went heavier in front because my inside rear was lifting on tight turns. Rear is 17.5lbs or 20 I think. I am running 350 weight oil. My shocks are not idea yet but are close. They are one of the last things I change. What I have works, but I am always looking for an extra .1 seconds. Change the roll centers then go from there. Not being able to change tires makes things difficult as that is the most obvious thing to change. I run softer front tires than rear to offset the understeer I had with roll center changes. FYI, running 13.5 brushless spec, but changes to setup apply to all. |
Author: | Gary Lanzer [ Tue Jan 05, 2010 06:47:26 ] |
Post subject: | |
Author: | sidecarphil [ Tue Jan 05, 2010 22:54:17 ] |
Post subject: | |
Author: | Skiddins [ Wed Jan 06, 2010 02:40:27 ] |
Post subject: | |
Author: | David_Ehrbar [ Wed Jan 06, 2010 10:42:23 ] |
Post subject: | |
Author: | Skiddins [ Sat Jan 16, 2010 19:45:26 ] |
Post subject: | |
Here is the meeting from Jan 3rd that I had grip roll at, I run 10.5 but the video is one of the Mod A-Finals, the orange car at the front is Elliot Harper's Tamiya. Skiddins |
Page 1 of 2 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |