XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
T3 Build question, Front Spool https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=9963 |
Page 1 of 1 |
Author: | vortex [ Tue Dec 08, 2009 22:58:20 ] |
Post subject: | T3 Build question, Front Spool |
Building my T3 last night (EU Rubber Edition) and the spool comes with two screws that go through the outdrives. In mine, the screws just 'sit' there, they don't screw into anything and don't actually do anything. Is that correct? I don't see the point of them if that's all they do, or did I miss something? |
Author: | RCMD [ Tue Dec 08, 2009 23:14:06 ] |
Post subject: | |
Put a little pressure on them when you screw them in. They should catch the threads and go right in. Took me a minute to figure that out as well. |
Author: | Skiddins [ Wed Dec 09, 2009 00:17:44 ] |
Post subject: | |
When doing the screws up, pull the outdrive out slightly so that as you are screwing them in the move inwards along with the screw, this way you can do up the screws without going too far and ruining the thread. That way the spool can be used again if you break an outdrive. But yes, they are very stiff to get 'started' in the spool. Skiddins |
Author: | edijzer [ Wed Dec 09, 2009 16:16:19 ] |
Post subject: | Re: T3 Build question, Front Spool |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |