I have a question on the camber change.
I built my T3EU as the manual suggested.
- Camber link: #3 holes on both the front and rear shocks tower
- Shim: Rear 4mm shim above the upright / Front 1mm above c-hub.
- Camber: rear 2deg / front 1.5deg
When setting camber (Hudy setup system), I push down in the center of the shock towers, I notice no camber change at the rear and only +0.5deg in the front. If I push down on one side, say rear right side of the shock tower, the rear right would become 1deg camber and the left become 3deg.
I think this is wrong? Since I thought the side being push down should have more camber for more traction? I also have a t2 009, also using #3holes, but the camber change in the 009 is normal.
Anyone, please? Thank you in advance.
|