XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
2.5mm carbon fibre plate for front bumper question. https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=967 |
Page 1 of 1 |
Author: | murfy [ Thu Feb 03, 2005 09:34:44 ] |
Post subject: | 2.5mm carbon fibre plate for front bumper question. |
Author: | supadan [ Thu Feb 03, 2005 09:41:17 ] |
Post subject: | |
Author: | copter [ Thu Feb 03, 2005 11:29:10 ] |
Post subject: | |
Or you can do it this way too: Those plastic bits are originally from Losi XXX-S sway bar kit. You need to be very carefull when drilling those holes into carbon fibre since they need to be exactly in same positions than they are in composite plate. |
Author: | l150040 [ Thu Feb 03, 2005 11:58:26 ] |
Post subject: | |
Change little bit longer screws to bumper upper holder. Put anti-roll Bar mounts (303410) under these screws. Now you can use anti-roll bar and carbon bumper upper holder. Unfortunately I haven't had any photo from my car. The anti-roll bar comes this way little bit more back, put at least at my car it has worked very well |
Author: | supadan [ Fri Feb 04, 2005 00:01:01 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |