XRAY - Model racing cars

Running on polished floor leaning towards low grip.

I changed the Roll Center to -0.75 on both front and back to achieve more grip and less over steer on corner exit, but the axles touch the Anti Roll Bars at the rear is this normal???

Is it best I stick with T2 009 EU setup in manual with rear at 0.00 and front at +0.75 or should I change both front and rear to 0.00???

You can lengten the link between the arm to the anri roll bar.

Hi, you mean twist the plastic ball joints a bit more apart.

The manual says the rear should be 27mm long, so it's OK to just adjust them?

It won't throw something else off?

its ok to make them a little bit longer. There wont be any noticable difference. But make sure that it's equal left to right.

thanks

by the way do you think lowering the roll center to -0.75 will make a huge difference to low grip tracks countering oversteer on corner exit?