XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Roll Center T2 009 EU Problem https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=9642 |
Page 1 of 1 |
Author: | lucas-TC [ Sun Sep 06, 2009 11:43:50 ] |
Post subject: | Roll Center T2 009 EU Problem |
Running on polished floor leaning towards low grip. I changed the Roll Center to -0.75 on both front and back to achieve more grip and less over steer on corner exit, but the axles touch the Anti Roll Bars at the rear is this normal??? Is it best I stick with T2 009 EU setup in manual with rear at 0.00 and front at +0.75 or should I change both front and rear to 0.00??? |
Author: | David_Ehrbar [ Mon Sep 07, 2009 16:29:23 ] |
Post subject: | |
You can lengten the link between the arm to the anri roll bar. |
Author: | lucas-TC [ Mon Sep 07, 2009 16:44:22 ] |
Post subject: | |
Hi, you mean twist the plastic ball joints a bit more apart. The manual says the rear should be 27mm long, so it's OK to just adjust them? It won't throw something else off? |
Author: | David_Ehrbar [ Mon Sep 07, 2009 17:48:07 ] |
Post subject: | |
its ok to make them a little bit longer. There wont be any noticable difference. But make sure that it's equal left to right. |
Author: | lucas-TC [ Mon Sep 07, 2009 18:27:59 ] |
Post subject: | |
thanks by the way do you think lowering the roll center to -0.75 will make a huge difference to low grip tracks countering oversteer on corner exit? |
Author: | David_Ehrbar [ Tue Sep 08, 2009 10:02:00 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |