XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Spool Problems https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=9146 |
Page 1 of 1 |
Author: | wiscnitro [ Fri May 01, 2009 19:24:55 ] |
Post subject: | Spool Problems |
I have been using a friends Spool in my fron end to test against a oneway. the problem im having is the screws that hold the outdrives into the spool were too short so I had to use longer ones then what comes with it but the out drive still comes loose and I end up with 3 wheel drive 1/2 way throught a race. the spool is plastic and if I tighten the screw too much the put drives get jamed on the berring cups and the spool wont turn. is there a cure for this or is the spool just not ment for the car |
Author: | ldp787 [ Fri May 01, 2009 20:39:27 ] |
Post subject: | Spool |
Author: | wiscnitro [ Fri May 01, 2009 21:04:50 ] |
Post subject: | |
Author: | ldp787 [ Sat May 02, 2009 03:00:51 ] |
Post subject: | Spool |
Author: | wiscnitro [ Sat May 02, 2009 19:37:42 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |