How can you heat shrink around the 009 driveshafts to stop the pin coming out as they are half moons not full circles like the 008 one
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| DriveShaft 009 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=8955 |
Page 1 of 1 |
| Author: | AndyBird [ Tue Mar 17, 2009 14:31:32 ] |
| Post subject: | DriveShaft 009 |
| Author: | WEST [ Tue Mar 17, 2009 15:15:59 ] |
| Post subject: | |
| Author: | AndyBird [ Wed Mar 18, 2009 00:56:22 ] |
| Post subject: | |
| Author: | teehomo [ Thu Mar 19, 2009 04:30:55 ] |
| Post subject: | |
| Author: | AndyBird [ Mon Mar 23, 2009 00:23:55 ] |
| Post subject: | |
| Author: | rx7ttlm [ Tue Mar 24, 2009 22:30:05 ] |
| Post subject: | |
| Author: | AndyBird [ Wed Mar 25, 2009 21:52:28 ] |
| Post subject: | |
How can you heat shrink around the 009 driveshafts to stop the pin coming out as they are half moons not full circles like the 008 one
|
|
| Author: | markone [ Tue Mar 31, 2009 12:16:05 ] |
| Post subject: | pins |
I had this problem too, the fix that worked for me is to grind a small flat with a dremmel on the pin where the grub screw hits it. It has not come out since. Cheers. 
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|