| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| what can i do to stop lipo touching spur https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=8565 |
Page 1 of 1 |
| Author: | Ronaldo808 [ Thu Dec 18, 2008 22:56:20 ] |
| Post subject: | what can i do to stop lipo touching spur |
| Author: | ianp [ Thu Dec 18, 2008 23:19:18 ] |
| Post subject: | |
| Author: | Ronaldo808 [ Fri Dec 19, 2008 00:06:56 ] |
| Post subject: | |
| Author: | Ronaldo808 [ Fri Dec 19, 2008 00:09:41 ] |
| Post subject: | |
| Author: | chris_dono [ Fri Dec 19, 2008 01:54:37 ] |
| Post subject: | |
| Author: | rx7ttlm [ Fri Dec 19, 2008 09:12:26 ] |
| Post subject: | Re: what can i do to stop lipo touching spur |
| Author: | TeamGPT 8 [ Fri Dec 19, 2008 17:29:59 ] |
| Post subject: | |
| Author: | Ronaldo808 [ Fri Dec 19, 2008 22:31:35 ] |
| Post subject: | |
| Author: | Ronaldo808 [ Fri Dec 19, 2008 22:33:17 ] |
| Post subject: | |
| Author: | Empo [ Sat Dec 20, 2008 20:13:03 ] |
| Post subject: | |
This is how i have done. Took some scrap parts and made a stop to prevent the lipo sliding towards the spur gear. This is done without the need to do any modifications to the "expensive" chassi It´s made of a screw, nut and 2 distances i had laying around. Also there is a small carbon fiber plate that i grinded down until the Lipo perfectly fits in the chassi. This may prevent some of the "flexing" ??? . The LiPo fits supertight !. The LiPo also have "knobs" underneath that fits the cell slots in the chassi |
|
| Author: | YELLOWSHARK [ Sun Dec 21, 2008 22:05:09 ] |
| Post subject: | |
| Author: | Empo [ Tue Dec 23, 2008 00:31:51 ] |
| Post subject: | |
If i do so, i cant place my LiPo´s proper in the cell-slots in the chassi ? |
|
| Author: | chris_dono [ Wed Dec 24, 2008 02:40:10 ] |
| Post subject: | |
| Author: | chris_dono [ Wed Dec 31, 2008 01:35:50 ] |
| Post subject: | |
as promised.... Central Battery Holder (cut the lug off the bottom and simply screw into place as below) Corner battery holder (installed on opposite corners): |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|