XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Xray T2 008 Alu Shocks: Which Pistons To Use? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=8084 |
Page 1 of 1 |
Author: | MattWinyard [ Thu Jul 31, 2008 14:41:29 ] |
Post subject: | Xray T2 008 Alu Shocks: Which Pistons To Use? |
Author: | G0DFATHER [ Thu Jul 31, 2008 22:27:34 ] |
Post subject: | |
Author: | YELLOWSHARK [ Fri Aug 01, 2008 00:30:39 ] |
Post subject: | |
Author: | brano [ Fri Aug 01, 2008 07:47:51 ] |
Post subject: | |
XRAY Oil Conversion Table |
Author: | G0DFATHER [ Fri Aug 01, 2008 07:57:47 ] |
Post subject: | |
Thanks Brano! |
Author: | MattWinyard [ Fri Aug 01, 2008 09:18:37 ] |
Post subject: | |
[quote="YELLOWSHARK"]General view seems to be that original holes were 0.9 mm, which gives you 2.7mm which suggest 2 holes at 1.3mm [quote] That does make sense. Last night when I started building the shock absorbers I took apart my original plastic shocks and measured the 3 hole system I was using, worked out about 0.9-0.95mm diameter thus I used the 3 hole system on the alu shocks with the 1.1 piston. Will that make a big difference? or should I try 2 hole @ 1.3? |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |