XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Final Drive Ratio for 10.5 brushless https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=8029 |
Page 1 of 1 |
Author: | jarosujo [ Sat Jul 19, 2008 20:40:59 ] |
Post subject: | Final Drive Ratio for 10.5 brushless |
Hi, I had my first race today, it was really great. I have Xray 008 EU, 6 nimh cells, 10.5 brushless LRP Vector X11 250W motor and I was racing against drivers with 19 brushed motors. I have original 38T/16T pulleys, 23T pinion, 84T spur gear = FDR 8.67. I was able to fight with them on slow part of the track, but on the long straight part my maximum speed was much lower. I am sure many of you are using this motor, what pinion do you use ? Also what setup would you recommend for Nosram Matrix evo 07 esc ? thanx a lot |
Author: | kevinkirk [ Sat Jul 19, 2008 20:58:57 ] |
Post subject: | |
Hi There I all depends on the size of your track but i use 5.5 overall on a open track (about 10 second laps) |
Author: | jarosujo [ Sat Jul 19, 2008 21:04:24 ] |
Post subject: | |
What motor ? 5.5 compared to 8.67 - big difference. Can you share your pinion size ? I was at bigger track, about 17 sec a lap. |
Author: | jarosujo [ Sat Jul 19, 2008 21:09:15 ] |
Post subject: | |
Hm, I checked my TX (Futaba megatech 3PM), throttle EPA was at 100% but I can go to 120%. Will it make any change to my maximum speed ? |
Author: | kevinkirk [ Sun Jul 20, 2008 17:12:50 ] |
Post subject: | |
Author: | jarosujo [ Sun Jul 20, 2008 17:27:18 ] |
Post subject: | |
Author: | kevinkirk [ Mon Jul 21, 2008 21:37:06 ] |
Post subject: | |
Author: | jarosujo [ Tue Jul 22, 2008 07:18:42 ] |
Post subject: | |
Author: | xbspud [ Tue Jul 29, 2008 02:52:20 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |