Thanks Adam all clear now
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Question about the steering servo in an T2 008 EU spec https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=8026 |
Page 1 of 1 |
| Author: | Twotone [ Fri Jul 18, 2008 18:52:23 ] |
| Post subject: | Question about the steering servo in an T2 008 EU spec |
Just wondering, according to the instructions the linkage and server arm should form a 90 degree angle. I have the linkage as short as I can make it and there is no way it will form a 90 angle, not even close. I can't even see how it's possible, the output shaft of the servo would have to be right next to the mounting post. Am I missing something?? Would some mind posting a picture of their set up? BTW I'm using a Spektrum DX with the stock high torque #Z590 Thanks for any help |
|
| Author: | circusmonkey [ Mon Jul 21, 2008 05:23:30 ] |
| Post subject: | |
| Author: | adamg [ Mon Jul 21, 2008 06:05:36 ] |
| Post subject: | |
| Author: | circusmonkey [ Mon Jul 21, 2008 10:04:13 ] |
| Post subject: | |
This is what my servo link looks like without the turnbuckle. |
|
| Author: | Suwardi Suliandy [ Tue Jul 22, 2008 09:22:59 ] |
| Post subject: | |
Use shorter ballcup or cut the long one to desired measurement and move 1-click to the right of the servo horn (with servo in neutral position). You should be able to make 90 deg angle. Later, check your steering EPA (left and right) to make balanced throw. |
|
| Author: | YELLOWSHARK [ Tue Jul 22, 2008 14:49:59 ] |
| Post subject: | |
This is something I have never dwelt on. What is the advantage of being at 90 deg as against not? Is it servo dependent? |
|
| Author: | adamg [ Fri Jul 25, 2008 05:22:26 ] |
| Post subject: | |
| Author: | YELLOWSHARK [ Sat Jul 26, 2008 23:50:26 ] |
| Post subject: | |
| Author: | adamg [ Sun Jul 27, 2008 00:21:03 ] |
| Post subject: | |
| Author: | YELLOWSHARK [ Sun Jul 27, 2008 19:48:17 ] |
| Post subject: | |
Thanks Adam all clear now
|
|
| Author: | Twotone [ Thu Jul 31, 2008 03:25:52 ] |
| Post subject: | |
| Author: | G0DFATHER [ Thu Jul 31, 2008 09:14:24 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|