XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Spur and Pinion https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=7871 |
Page 1 of 1 |
Author: | crypttos [ Wed Jun 18, 2008 06:24:12 ] |
Post subject: | Spur and Pinion |
Hi guys I have just bought and setup my first car. It is T2 008. I want to use for onroad stock class 540 brushed engine now. I need to change the size of spur and pinion. I was trying to use Spur 84 and Pinion 27 and this is not possible. I can use 84/26. But I have to go lower with Final Drive ration. I hope that I will have enough place to install 78/32(4.14 ratio). Is it right? Is it possible to buy a smaller spur then 78? I would like to go down to 3.81 ratio. |
Author: | YELLOWSHARK [ Wed Jun 18, 2008 08:46:34 ] |
Post subject: | Re: Spur and Pinion |
Hi Crypttos, OK you are saying a maximum of 110 teeth. In theory I think that should be consistent given any combiniation but I think it can vary by 1 tooth either way. Interestingly on 78 spur I have run 111 teeth and I am sure my maximum is 112 teeth, so I would have thought 78/32 would have been fine I do not know if Xray have released additonal spurs below 78 but if not RW Racing have them below 78 and specially made for the 008. |
Author: | crypttos [ Wed Jun 18, 2008 10:43:46 ] |
Post subject: | |
It is interesting, I was trying spur 84 with 27 and I couldn't use it it is 111. Maybe is not possible with this type of motor. I can't to move more to side. I don't have 78 spur now, so I can't to test but if I understand you correctly. If its is maximum for me 110, it would be no different with spur 78...with this engine I have to count 110 again = 78+32. If I have to go down I have to buy smaller spur. 76/34 that I get 3.8. Thanks a lot for answer and for tip where I can buy it. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |