XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Adjusting the rear end https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=771 |
Page 1 of 1 |
Author: | coledog855 [ Sun Jan 09, 2005 05:35:38 ] |
Post subject: | Adjusting the rear end |
I'm using the Xray Evo2 with C-hub suspension. How do I adjust the rear toe-in? |
Author: | PlainOleDave [ Sun Jan 09, 2005 06:03:17 ] |
Post subject: | |
Shims/washers between the pivot mounts and the bulkheads. |
Author: | coledog855 [ Sun Jan 09, 2005 22:07:21 ] |
Post subject: | |
thank you, so 0 washers mean 0 toe-in? That's what mines at and it looks wrong. |
Author: | PlainOleDave [ Sun Jan 09, 2005 23:34:48 ] |
Post subject: | |
Page 01 of the C-hub instructions says refer to setup book for Rr toe adj. |
Author: | Tonyv [ Mon Jan 10, 2005 00:47:27 ] |
Post subject: | |
Yes, 0mm washers means zero toe-in. I am assuming you have the long arms as you said you have the EVO2. If so you need to put spacers between the bulkhead and the front pivot pin holder for the rear arms. rule of thumb is that 1mm spacer = 1 degree. A good starting point is 2mm spacers. If you run the short arms mounted to the outside of the bulkheads you need to put the spacer between the rear pivot pin holder and the bulkhead instead. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |