XRAY - Model racing cars

I'm using the Xray Evo2 with C-hub suspension. How do I adjust the rear toe-in?

Shims/washers between the pivot mounts and the bulkheads.

thank you, so 0 washers mean 0 toe-in? That's what mines at and it looks wrong.

Page 01 of the C-hub instructions says refer to setup book for Rr toe adj.

Yes, 0mm washers means zero toe-in. I am assuming you have the long arms as you said you have the EVO2. If so you need to put spacers between the bulkhead and the front pivot pin holder for the rear arms. rule of thumb is that 1mm spacer = 1 degree. A good starting point is 2mm spacers.

If you run the short arms mounted to the outside of the bulkheads you need to put the spacer between the rear pivot pin holder and the bulkhead instead.