XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
over steer https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=7045 |
Page 1 of 1 |
Author: | mark [ Sun Feb 03, 2008 15:29:22 ] |
Post subject: | over steer |
hi,i know this has been spocken about before,but iv just fine tuned my servo so the steering block just kiss the hubs,now iv done this when i get so a sharp corner the car just swops ends,the wheels turn smoothly then the last 3% of the angle they just snap round,the only thing iv changed from the origional set up for the EUrubber is the shims on all for camber links and to use the upper holes,is this somthing i should learn to use or do you not use all the steering angle in your set ups thanks mark |
Author: | adamg [ Sun Feb 03, 2008 18:55:09 ] |
Post subject: | |
Author: | YELLOWSHARK [ Sun Feb 03, 2008 22:55:34 ] |
Post subject: | |
I would suggest you should be looking for between 14-18 degrees on the inner wheel. Start hitting 19-20 degrees and you will be losing corner speed. No idea at what point your rear end will overtake your front end though as I run a max of 17. |
Author: | mark [ Sun Feb 03, 2008 22:58:21 ] |
Post subject: | |
thanks YELLOWSHARK,i will dial some out mark |
Author: | YELLOWSHARK [ Mon Feb 04, 2008 22:27:49 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |