XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Rubber tyre wear https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=685 |
Page 1 of 1 |
Author: | Dave Treacy [ Fri Dec 24, 2004 01:06:54 ] |
Post subject: | Rubber tyre wear |
Author: | apexracing [ Fri Dec 24, 2004 01:10:32 ] |
Post subject: | |
Author: | coledog855 [ Fri Dec 24, 2004 01:14:33 ] |
Post subject: | |
Author: | Tonyv [ Fri Dec 24, 2004 12:31:17 ] |
Post subject: | |
If you see the outsides wear more than the insides you are definitely running too little camber. Try running 1.5 degrees and even 2 degrees if the outside still wear faster. In principle you will be generating maximum grip if the middle of the tyres are the primary contact point with the track surface. If you have the camber setup that way the tyres should wear evenly. Having said that you need to keep in mind that you may purposely run the camber for the front or rear tyres (or left-right if running oval) on a "suboptimal" setting to balance the car out. |
Author: | Big Jimmy G [ Fri Dec 24, 2004 20:54:20 ] |
Post subject: | |
Author: | Dave Treacy [ Mon Dec 27, 2004 18:00:00 ] |
Post subject: | |
Jimmy, I'm running on inch up with 038's as well. I'll try going to 2degrees and see how the wear goes. |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |