thanks NES
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| tightening rear diff https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=6840 |
Page 1 of 1 |
| Author: | mark [ Sun Dec 30, 2007 21:38:49 ] |
| Post subject: | tightening rear diff |
| Author: | Nes [ Sun Dec 30, 2007 21:44:17 ] |
| Post subject: | |
| Author: | mark [ Sun Dec 30, 2007 21:55:49 ] |
| Post subject: | |
iv had a look at the one i got with the kit and it says you undo the rear link to move the shaft and then do up the screw in the sid of the diff,im not stupid,but there isnt one,there is a cap in one end and the other side there is the thread end of the screw, mark |
|
| Author: | Nes [ Sun Dec 30, 2007 21:58:59 ] |
| Post subject: | |
u tighten it the same way as you put it together, put a thin rod or something through the side of the diff and spin the opposite wheel to tighten it. |
|
| Author: | mark [ Sun Dec 30, 2007 22:00:23 ] |
| Post subject: | |
iv just read that link and its not the same as the one iv got,am i right that i hold one side of the diff solid and turn the other side |
|
| Author: | mark [ Sun Dec 30, 2007 22:01:19 ] |
| Post subject: | |
thanks NES
|
|
| Author: | Hurrle [ Mon Dec 31, 2007 00:43:49 ] |
| Post subject: | |
Tha manual itself refers to the composite diff that was supposed to come with the T2'008, but there is an additinal sheet with building and maintenace instruction included in the manual on the same page. |
|
| Author: | eppikk [ Wed Jan 02, 2008 18:30:18 ] |
| Post subject: | |
Just a quick question: How tight should it be, can you guys give some reference point for us to know (strenght needed to spin, etc..)? |
|
| Author: | YELLOWSHARK [ Thu Jan 03, 2008 00:30:41 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|