tightening rear diff

mark · **Posted:** Sun Dec 30, 2007 21:55:49

iv had a look at the one i got with the kit and it says you undo the rear link to move the shaft and then do up the screw in the sid of the diff,im not stupid,but there isnt one,there is a cap in one end and the other side there is the thread end of the screw,
mark

Nes · **Posted:** Sun Dec 30, 2007 21:58:59

u tighten it the same way as you put it together, put a thin rod or something through the side of the diff and spin the opposite wheel to tighten it.

mark · **Posted:** Sun Dec 30, 2007 22:00:23

iv just read that link and its not the same as the one iv got,am i right that i hold one side of the diff solid and turn the other side

mark · **Posted:** Sun Dec 30, 2007 22:01:19

thanks NES

Hurrle · **Posted:** Mon Dec 31, 2007 00:43:49

Tha manual itself refers to the composite diff that was supposed to come with the T2'008, but there is an additinal sheet with building and maintenace instruction included in the manual on the same page.

eppikk · **Posted:** Wed Jan 02, 2008 18:30:18

Just a quick question:

How tight should it be, can you guys give some reference point for us to know (strenght needed to spin, etc..)?

YELLOWSHARK · **Posted:** Thu Jan 03, 2008 00:30:41

XRAY - Model racing cars

tightening rear diff

Who is online