XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
HELP Please T2R conversion to 2007 spec - steering prob https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=6597 |
Page 1 of 1 |
Author: | malc50 [ Fri Nov 16, 2007 01:13:50 ] |
Post subject: | HELP Please T2R conversion to 2007 spec - steering prob |
Author: | FOXY923 [ Fri Nov 16, 2007 02:27:37 ] |
Post subject: | |
Author: | malc50 [ Fri Nov 16, 2007 10:03:16 ] |
Post subject: | |
Author: | bmc [ Fri Nov 16, 2007 12:55:07 ] |
Post subject: | |
Author: | FOXY923 [ Fri Nov 16, 2007 16:52:08 ] |
Post subject: | |
Author: | YELLOWSHARK [ Sat Nov 17, 2007 01:42:42 ] |
Post subject: | |
Author: | pilot [ Sat Nov 17, 2007 05:46:17 ] |
Post subject: | Servo |
Author: | FOXY923 [ Sat Nov 17, 2007 06:32:37 ] |
Post subject: | Re: HELP Please T2R conversion to 2007 spec - steering prob |
Author: | AndyBird [ Sat Nov 17, 2007 12:55:02 ] |
Post subject: | |
Author: | malc50 [ Sun Nov 18, 2007 21:26:10 ] |
Post subject: | |
Thks for all your help..... In the end I shimmed it and took a small amount off the servo side of the servo horn. It does seem strange the way you set the steering up with the servo horn fwd of vertical for straight ahead. You seem to get far better responce when the servo moves to the back of the car than the front. As it moves fwds you get very near to the ponit when servo movement is not translated into steering at all if that makes sense!! any way ran the car seemed ok but i might look into it a bit further... Thks again for all your help Malc |
Author: | chris_dono [ Sat Dec 01, 2007 03:24:47 ] |
Post subject: | |
I had the same thing when I converted... I had a t2r and had to shave some off the servo horn, and when I upgraded to the 007, it caught on the top deck. I took it all apart and looked carefully at the diagram, the little ball end that goes into the horn was on the wrong side (as per the t2r it was on the side of the top deck). I changed it over to the side closest to the servo and there's no issues now |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |