XRAY - Model racing cars

I see you've posted . We need you to fill out the following items on it before we can give you advice:

* Is the shock oil XRAY brand or another?
* Did you put the foam inserts into the shock bladders?
* Are you using tire traction compound (additive). If so, fill in how much of the tires you are using it on by checking the 'treated area' boxes
* What brand/turn motor are you using (Monster, Checkpoint, etc/27t, 19t, etc.)
* Replace the '3x5x1' rear shim size with only the thickness of the shim (I'm assuming its a 1mm thick shim)
* Check the correct box for the amount of rear in-board toe-in shim size
* Are you actually using 1d of front toe-IN or did you mean toe-OUT?
* check the correct boxes for tghe servo saver inner ackermann position (1 or 2) and the adjustable position (1, 2, 3, 4 or 5)
* Are you actually using 3mm of shims between the rear bulkheads and the rear arm suspension holders? You also checked the 1.5mm shim.
* You have both the inner and outer top deck pylon positions checked, but you can only be using one or the other.
* Are you actually not using the 4 screws on the bottom chassis that are indicated? Or do you really have all the screws in the bottom of the chassis?
* Make sure you check Rubber tires, as I'm assuming this is the case since you have vtec 24r tires listed. This will allow the search engine to show your setup if someone else does a search for rubber tire setups.

I know this is a lot, but trust me that we need to see the whole picture correctly.

Also, how did you arrive at this setup? Have you tried the basic rubber tire setup or one of the team drivers rubber tire setups?