XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Roll Out or Gear Ratio ? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=596 |
Page 1 of 1 |
Author: | huskerfreak [ Fri Dec 10, 2004 02:11:11 ] |
Post subject: | Roll Out or Gear Ratio ? |
Author: | calvin [ Fri Dec 10, 2004 10:07:10 ] |
Post subject: | |
Personally, I'd drop about 3 teeth for stock (30T) and start from there. I run a P2K2. The proper gearing may differ by 5 teeth or more depending on the motor, etc. Gear only for lap time. This is about the only thing that can bring all the variables together (after all whomever goes around the fastest wins). A 128T spur will also help lower the motor a little bit in the chassis. Good luck. Gearing questions are almost impossible to answer unless you are intimately familiar with all the variables. |
Author: | huskerfreak [ Fri Dec 10, 2004 15:16:58 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |