XRAY - Model racing cars

Hey all -

Cant seem to get my T2 to hook up, all I get is serious spin and no traction. The basic rubber set up is being used.

Was wondering how to set up the multi-flex technology? I have all the stands and screws installed, wondering it's just too damn stiff to allow traction???

Running a NOVAK 3.5 brushless, stiff dampers, soft to med-soft springs, no roll bars, diffs are med loose - loose, also added the KM Concepts aluminum heat sink/center brace to the rear. I have tried may different set ups and just cant get it right... please help if you can

Guess I'll try tightening the belts and give it another run.

Thanks,

Scott

I have the same motor and didn't use the stands and my car handles better than any of my TC4's.
The one thing I did notice was when I used the front diff as full locked the car just hugs the road so much better.

What pinion size are you using?

Mark 007,

Im using a 21 tooth pinion gear, too much? Gear up or down?

When adjusting diffs do you guys hold the outdrives and test the tightness by trying to turn the ring gear? Im not that stupid but am still learning...I mean, I am adjusting these with them out of the car correct?

I have the same problem with the spin out, car will not hook up. I have the same setup, my ride height is 5.5 frt and 6.0 rear, white springs, front & rear sway bars, stands in place, droop 5 frnt 4 rear. Running 13.5 brushless. 4.8 final.

I will loose the stands, any other suggestions, sorry for hi-jacking thread.