XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
no happy medium https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=5302 |
Page 1 of 1 |
Author: | scottschory [ Fri Apr 20, 2007 05:59:27 ] |
Post subject: | no happy medium |
Hey all - Cant seem to get my T2 to hook up, all I get is serious spin and no traction. The basic rubber set up is being used. Was wondering how to set up the multi-flex technology? I have all the stands and screws installed, wondering it's just too damn stiff to allow traction??? Running a NOVAK 3.5 brushless, stiff dampers, soft to med-soft springs, no roll bars, diffs are med loose - loose, also added the KM Concepts aluminum heat sink/center brace to the rear. I have tried may different set ups and just cant get it right... please help if you can Guess I'll try tightening the belts and give it another run. Thanks, Scott |
Author: | the_penfool [ Fri Apr 20, 2007 13:18:10 ] |
Post subject: | |
Author: | Mark007 [ Fri Apr 20, 2007 22:09:47 ] |
Post subject: | |
I have the same motor and didn't use the stands and my car handles better than any of my TC4's. The one thing I did notice was when I used the front diff as full locked the car just hugs the road so much better. What pinion size are you using? |
Author: | matt6005 [ Sat Apr 21, 2007 05:35:13 ] |
Post subject: | |
Author: | scottschory [ Sat Apr 28, 2007 21:27:54 ] |
Post subject: | |
Mark 007, Im using a 21 tooth pinion gear, too much? Gear up or down? |
Author: | scottschory [ Sat Apr 28, 2007 21:32:46 ] |
Post subject: | Diifs |
When adjusting diffs do you guys hold the outdrives and test the tightness by trying to turn the ring gear? Im not that stupid but am still learning...I mean, I am adjusting these with them out of the car correct? |
Author: | Tonyv [ Sun Apr 29, 2007 22:03:20 ] |
Post subject: | |
Author: | MACHTQ [ Mon Apr 30, 2007 17:09:35 ] |
Post subject: | |
I have the same problem with the spin out, car will not hook up. I have the same setup, my ride height is 5.5 frt and 6.0 rear, white springs, front & rear sway bars, stands in place, droop 5 frnt 4 rear. Running 13.5 brushless. 4.8 final. I will loose the stands, any other suggestions, sorry for hi-jacking thread. |
Author: | MACHTQ [ Tue May 01, 2007 16:52:36 ] |
Post subject: | |
Author: | teamgp [ Tue May 01, 2007 23:39:15 ] |
Post subject: | |
Author: | MACHTQ [ Tue May 01, 2007 23:46:16 ] |
Post subject: | |
Author: | teamgp [ Wed May 02, 2007 20:02:26 ] |
Post subject: | |
Author: | Mark007 [ Mon May 07, 2007 19:41:35 ] |
Post subject: | |
Page 1 of 1 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |