| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Getting lost with the set up../.. https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=526 |
Page 1 of 1 |
| Author: | John Reid [ Sun Nov 28, 2004 02:19:34 ] |
| Post subject: | Getting lost with the set up../.. |
| Author: | Tonyv [ Sun Nov 28, 2004 11:09:57 ] |
| Post subject: | |
| Author: | chaz [ Tue Nov 30, 2004 01:44:17 ] |
| Post subject: | Re: Getting lost with the set up../.. |
| Author: | John Reid [ Tue Nov 30, 2004 06:05:50 ] |
| Post subject: | |
Hi Tony Here is the link. Did a few checks on the set up bench and found that the droop was not the same on both sides, found a little wear on the chassis under the grub screw which has altered the droop a bit. Took a bit of a hit on that corner during practice. I dont think that was my problem. Thanks for the advice, will have another attempt after New Year. I am back to work a week early to cover for a work mate who has Cancer so wont be racing till next year. |
|
| Author: | tboned [ Tue Nov 30, 2004 19:20:29 ] |
| Post subject: | |
| Author: | John Reid [ Tue Nov 30, 2004 21:17:07 ] |
| Post subject: | |
its just a template, you have to print the sheet off, you cannot save the changes you make, least i havnt figured out how to do it yet... The set up above is a scanned copy of a filled in set up sheet from the link above. |
|
| Author: | tboned [ Tue Nov 30, 2004 22:08:17 ] |
| Post subject: | |
thanks! time to throw away the ones from the evo 2! |
|
| Author: | Tonyv [ Wed Dec 01, 2004 14:49:04 ] |
| Post subject: | |
| Author: | Sam_Smith [ Wed Dec 01, 2004 16:49:17 ] |
| Post subject: | |
| Author: | Ole C [ Thu Dec 02, 2004 16:02:31 ] |
| Post subject: | |
| Author: | Orca [ Thu Dec 02, 2004 16:14:19 ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|