XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
Servo? https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=8&t=5179 |
Page 1 of 2 |
Author: | lextek [ Sat Mar 17, 2007 21:03:42 ] |
Post subject: | Servo? |
Author: | maxch [ Sat Mar 17, 2007 22:56:50 ] |
Post subject: | |
Author: | ChrisP [ Sun Mar 18, 2007 04:32:42 ] |
Post subject: | |
Author: | teamgp [ Sun Mar 18, 2007 14:46:38 ] |
Post subject: | Re: Servo? |
Author: | sirshan [ Fri Mar 23, 2007 21:01:03 ] |
Post subject: | |
Author: | jaxgough [ Sun Mar 25, 2007 17:48:52 ] |
Post subject: | Further Servo Question |
Author: | teamgp [ Mon Mar 26, 2007 15:34:50 ] |
Post subject: | Re: Further Servo Question |
Author: | jaxgough [ Mon Mar 26, 2007 15:53:49 ] |
Post subject: | |
Author: | teamgp [ Mon Mar 26, 2007 17:09:55 ] |
Post subject: | |
Author: | Jerry P [ Mon Mar 26, 2007 21:36:56 ] |
Post subject: | |
I believe the Futaba S9602 is a 1/12 scale servo. |
Author: | jaxgough [ Wed Mar 28, 2007 12:12:21 ] |
Post subject: | |
Author: | Ridge_Racer [ Wed Mar 28, 2007 20:54:22 ] |
Post subject: | Stearing Linkage rubbing on top deck |
Author: | adamg [ Wed Mar 28, 2007 23:38:46 ] |
Post subject: | |
Author: | bmc [ Thu Mar 29, 2007 01:36:42 ] |
Post subject: | |
I have a multiplex servo and had the same problem. With the T2 i filled the servo arm (looks like the T2007 arm now). On the T2007 i used spacers and filled the ball joint on the servo turnbuckle. I gained about 2mm there. Its possible to get the same clearance with more shims on the servo posts, but that makes my servo stick out of the chassis. |
Author: | kobiwon [ Thu Mar 29, 2007 17:02:16 ] |
Post subject: | |
Author: | teamgp [ Fri Mar 30, 2007 20:36:28 ] |
Post subject: | |
Author: | steve58 [ Sat Mar 31, 2007 16:23:06 ] |
Post subject: | |
How much spacing is needed for the PDS-2413 servo? I have a Hitec and cannot space it out enough because the length of the screws. |
Author: | teamgp [ Sat Mar 31, 2007 18:16:01 ] |
Post subject: | |
Author: | steve58 [ Mon Apr 02, 2007 03:52:44 ] |
Post subject: | |
Author: | teamgp [ Mon Apr 02, 2007 04:58:19 ] |
Post subject: | |
Page 1 of 2 | All times are UTC + 2 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |